Unit installation

GENERAL

INTRODUCTION

ZAMIL Cooline ASQ-Series liquid chillers are manufactured to provide engineering excellence in comfort air

conditioning and industrial cooling with a superior combination of energy saving, performance, application flexibility,

ease of service & maintenance, environmental friendliness and ability to withstand extreme ambient temperatures.

This manual contains all the information required for correct installation, start-up and commissioning of the units,

together with operating instructions. The manual should be read thoroughly before attempting to perform any of the

aforesaid tasks and all procedures and instructions detailed in this manual must only be carried out by suitably trained

and qualified personnel. The manufacturer will not be liable for any personnel injury or equipment damage caused by

incorrect installation, commissioning or operation resulting from a failure to follow and implement the procedures,

instructions and recommendations detailed in this manual.

SCOPE OF THIS MANUAL

The contents of this manual include suggested best working practices and procedures. These are issued for guidance

only and they do not supersede governing local safety codes/regulations nor the individual responsibility of the

personnel working on these units who shall remain primarily responsible for their own safety and the equipment as

well.

This manual, and any other documents supplied with the unit, are the sole property of Zamil Air Conditioners, which

reserves all rights. They may not be reproduced or distributed in any form or by any means, without prior written

permission from Zamil or its representatives.

In accordance with our policy for continuous research and product improvement, the information contained in this

manual is subject to change without notice. While Zamil makes no commitment to update or provide current

information automatically to the manual owner, that information, if applicable, can be obtained by contacting the

nearest Zamil or its representative’s offices. It is the responsibility of operating/service personnel to verify applicability

of this manual to the equipment involved. If they have any doubt with regards to the applicability of this document,

then, prior to working on the equipment, they should verify with the owner whether the equipment has been modified/

improved and if current literature is available.

SAFETY CONSIDERATIONS & SYMBOLS

This equipment is a complex engineering product and the personnel involved during installation, operation,

maintenance or service, may be exposed to certain components or conditions including, but not limited to: refrigerants,

oils, pressurized components, rotating parts and both high and low voltages. Each of these items has the potential, if

misused or handled improperly, to cause injury or death. It is the obligation of operating/service personnel to identify

and recognize these inherent hazards, protect themselves and proceed safely in completing their tasks. Failure of the

personnel to comply with any of these requirements could result in serious damage to this equipment and the facility,

in which it is installed, as well as severe injuries or death to themselves and other people at the site.

This manual is intended for use by owner authorized operating/service personnel. It is expected that these personnel

are suitably trained and qualified which will enable them to perform their assigned tasks properly and safely. It is

essential that prior to performing any task on this equipment, the personnel must have thoroughly read and

understood this manual, all tags and stickers on the units and any other applicable documents. These people shall

also be cognizant of and comply with all applicable local codes and regulations pertaining to the job on hand.

The major safety considerations are as follows and must be exercised during application, installation, start-up and

operation of these units:

Proper Design & Operation: These chillers are designed for cooling water or glycol solutions and not suitable for

purposes other than those specified in our application catalogue. Any misuse of this equipment, may result in injury to

the operator or damage to equipment. The units must not be operated beyond the domain of performance data

furnished in our application catalogue.