Operation Manual

INSTALLATION AND START-UP

1. Read all the instructions carefully before commissioning the appliance. Observe the safety instructions of this user

manual in particular.

2. The appliance must be in the upright position for at least 24 hours before start up. This condition is applicable most of

all after transportation.

3. Place the appliance on a ﬁrm, even surface. Ensure that it is stable so that the appliance does not fall down or topple

over. The discharged water can damage furniture and ﬂoor covers.

4. This appliance is equipped with a water tank which is fastened with a belt in the factory to protect the water level switch

during transportation. Take the water tank out and remove the fastening tape and replace the water tank in its initial

position before the ﬁrst start-up. Do not push or apply sudden force on the tank, as this could lead to faults in the

appliance. Information about the correct handling of the water tank is available in the Chapter entitled “Water Tank” in

this use instructions document.

5. Maintain a safety distance of about 30 cm at the front and rear side of the appliance from other objects. The appliance

should not be placed under tables or in cabinets, because then the airﬂow is restricted.