Specifications

completed, the disk will be available for optimal use.
When exactly one SAFE volume exists, you can request a drive rebuild if the disk was
marked bad or a previous rebuild operation was aborted. To start the rebuild, select Action
Start Rebuild Select Drive n. Once a rebuild process has been started, it can also be
aborted.
Once the rebuild has taken place, the Verify process will begin automatically if your system
is configured to do so. If the rebuild process is ever interrupted, the rebuild process will
resume from the last 10 GB segment that was completed before the interruption occurred.
Verify Rebuild
To confirm that the two hard disks that comprise a single SAFE volume are exact copies, you
can also execute a Verify Disk task manually.
When the CoolMax CD-320 is powered on and you select “Start Verify”, there is a 60
second delay. The “Start Verify” selection will be disabled during this time. Otherwise, if
the drive is in normal or verify abort mode, you can manually start the verify operation.
A pop-up will inform you of the action taking place.
Abort Rebuild
To abort a rebuild process that is already active, select Action Abort Rebuild. The rebuild