Product Manual

8
6.1 Troubleshooting (continued)
Water System
The water distribution system consists of two (2) assemblies:
o The Water Inlet Assembly
 Brass bulkhead fitting
 Float valve assembly
o The Hose and Valve Assembly
 Spray Bar Assembly
 Valve Assembly
 Connection Hose
Problem
Check
Solution
Floor at side of COOL-SPACE
®
unit is wet
Water inlet hose is loose at
supply hose or inlet hose is
loose at bulkhead fitting.
Tighten connections and/or
replace hose washers.
COOL-
SPACE
®
unit overflows
from reservoir or is spitting
water through fan.
Float valve is loose.
Water pressure is too high to
allow float valve to shutoff
(120psi max).
Float valve is not seating
properly.
Tighten connections and/or
replace hose washers.
Reduce water pressure by
adding an inline reducer.
Check all hoses for leaks.
Water spitting from the unit.
Flow control
Cracked Hose & Valve
Assembly.
Hose connection loose
Reduce flow
Replace Hose & Valve
Assembly.
Tighten hose.
Water leaking from drain valve.
For worn washer, worn stem.
Make sure drain valve is closed
Replace washer.
Replace drain valve.
Water leaking from water flow
control valve.
Washer worn. Stem worn.
Jammed nut or lock nut loose.
Replace water flow control
valve. Tighten Jam nut.
Too many dry streaks in the
pads
Holes in spray bar blocked.
Adjust water flow.
Remove spray bar. Remove
plug and clean tube and
holes. Open water flow
control valve.