Product Manual

1) After removing the air conditioner from the box, place in an upright position.
2) Remove the cable from the drawer at the back of the unit and insert the plug into a
wall outlet. Make sure you push the drawer fully back in so it is flush with the back of
the unit. The unit will make a “beep” noise when plugged into power.
IMPORTANT
Always keep your air conditioner upright. It may have been stored or transported on
it’s side or laid flat by mistake, so please stand it upright for at least 12 hours before
plugging it into power and turning it on. Failing to do so may damage the unit.
3) Open the warm air deflector fully. This will turn on the unit and the compressor will
start.
4) Open the cold air deflector and allow 2 minutes for the air coming out to feel cold.
Use the remote control to adjust fan speed. Keep the temperature setting at 17°C
unless the air flow feels too cold.
C
AUTO
FUNC SLEEP
TIMER
AUTO
HIGH
LOW
MED
POWER
Cooling
Fan
Sleeping
Timer ON/OFF
Temperature
Automatic air
flow speed
High speed
Medium speed
Low speed
AUTO
HI
MED
LO
REMOTE
(COOL FOCUS MODELS)
Position your air conditioner close
enough for comfort. The ideal range
of distance is 1.5 - 3 meters. Arange
the angle of the cold air deflector
so cool air flows around face and
shoulders.
For sleeping, arrange your unit about 15cm from the
end of the bed. Both the cold air deflector and focus
enhancer can be adjusted to the desired angle so the
cool air flows over you. It also works with larger beds for
two people.
MICROCLIMATE TEMPERATURE SETTING
The thermostat turns off the compressor if the temperature of the air returning to the
air conditioner is below the set temperature. Press ▲ to increase or ▼ to reduce the set
temperature. If the room temperature is lower than the set temperature, the compres-
sor will stop. The temperature of the cool air is dependent on the environment tem-
perature and humidiity, usually 8 to 14 degrees less than the ambient temperature.
SLEEP KEY
When this key is pressed, the air flow of the unit changes into sleep mode (low speed).
1) Press “SLEEP” to set sleep function. Press again to cancel sleep function.
2) The temperature will increase by 0.5°C after half an hour and 2°C after 2 hours.
3) When you turn off the unit, the sleep function will be cancelled automatically.
TIMER KEY
TIMER OFF: The timer is used to turn off the unit automatically after the setting time is
over.
1) Press the “TIMER” key to set the number of hours of desired operating time.
2) Once the set time has come to an end, the unit will turn off automatically.
3) Press the “POWER” key before the time out, the setting time will be cancelled and
the unit will turn off.
AUTO KEY
Automatic fan speed. When the ambient temperature is 2 or more degrees higher
than the set room temperature, the unit will run at high fan speed. it will automatically
switch to medium and low when the ambient temperature gets closer to the set
temperature.
5) Keep a door or window open so fresh air circulates unless it is extremely hot or
windy outside.
6) Avoid using a fan nearby as it can disrupt Close Comfort’s gentle air flow.
7) The focus enhancer extends the range of cooling and, after fitting the serparate
transparent deflector flap, enables a higher angle of air flow. Note: The focus enhancer
comes pre-installed on all COOL FOCUS models and is an optional accessory for EASY
FOCUS models.
For a small room, place
the unit near an open
window or doorway.
Drape a curtain as shown to
exclude light when sleeping.
Use the optional Igloo tent for a more
intense cooling effect and insect pro-
tection. We recommend using the
Igloo tent for sleeping if indoor
temperature is consistently over
27-29°C .
SETUP
3 4