User manual

20 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 945U-E Wireless Ethernet Modem & Device Server User Manual
Rev Version 2.14
LED Indication
The following table details the status of the indicating LEDs on the front panel under normal operating conditions.
LED Indicator Condition Meaning
OK Green Normal operation.
OK Flashing Red/Green Module boot sequence.
Radio RX Green flash Radio receiving data (good signal strength).
Radio RX Red flash Radio receiving data (low signal strength).
TX/LINK Green Radio connection established.
TX/LINK Red flash Radio transmitting.
RS-232 Green flash Data dent from RS-232 serial port.
RS-232 Red flash Data received yo RS-232 serial port.
LAN On Link established on Ethernet port.
LAN Flash Activity on Ethernet port.
RS-485 Green flash Data sent from RS-485 serial port.
RS-485 Red flash Data received To RS-485 serial port.
DIO Green Digital input is grounded.
DIO Red Digital output is active.
DIO Off Digital output off and input is open circuit.
The Ethernet RJ45 port incorporates two indication LEDs. The Link LED comes on when there is a connection on
the Ethernet port, and will blink off briefly when activity is detected on the Ethernet port. The 100-MB LED indicates
that the connection is at 100 MBit/sec. The 100-MB LED will be off for 10 MB/sec connection. Other conditions
indicating a fault are described in “Chapter 4 - DIAGNOSTICS.”
3.1 Selecting a Channel
802.11 (900 MHz) Channels
The 945U-E conforms to the IEEE 802.11 Wireless LAN specification and supports various channels depending on
regulations within the country of use.
If operating in the US, Canada, the frequency range is 902–928 MHz and the available channels are as follows:
• 9 x non overlapping 1.25-MHz channels
• 9 x partially overlapping 2.5-MHz channels
• 4 x non overlapping 5-MHz channels
• 4 x overlapping 10-MHz channels
• 2 x overlapping 20-MHz channels
If operating in Australia, the frequency range is 915–928 MHz and the available channels are as follows:
• 4 x non overlapping 1.25-MHz channels
• 4 x partially overlapping 2.5-MHz channels
• 3 x overlapping 5-MHz channels
• 1 x 10-MHz channel
If operating in Hong Kong, the frequency range is 922–925 MHz and the available channels are as follows:
• 2 x non overlapping 1.25-MHz channels
• 1 x 2.5-MHz channel