User manual
88 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 945U-E Wireless Ethernet Modem & Device Server User Manual
Rev Version 2.14
Register Module Description
5030-5036 As per 5010-5016 As per registers 5010-5016, but for the next wireless adapter (wi2).
5040-5046 As per 5010-5016 As per registers 5010-5016, but for the next wireless adapter (wi3).
.....etc As per 5010-5016 As per registers 5010-5016, but for the next wireless adapter (wi10).
5200 AP Only RSSI of the client (STA).
5201 AP Only Transmit data rate to client (STA).
5202 AP Only MAC address of client (STA).
.....etc AP Only Dynamic list of STAs. Refer to register 5023, 5033 (and so on) for
starting register of each wi interface.
9999 Both Reset module (enter FFFF to reset module).
Statistic Registers
Register Module Description
4500 Both Total data packets received on the interface.
4502 Both Received frames with antenna 1 (TX/RX).
4504 Both Received frames with antenna 2 (RX).
4506 Both Receiver / default antenna switches.
4508 Both Receive message failed due to bad CRC.
4510 Both Receive message failed due to decryption.
4512 Both Receive message failed due to MIC failure.
4514 Both Receive message failed due to FIFO overrun.
4516 Both Beacon missed interrupts.
4518 Both Total data packet sent on the interface.
4520 Both Transmit frames with antenna 1 (TX/RX).
4522 Both Transmit frames with antenna 2 (RX).
4524 Both Transmitter antenna switches.
4526 Both Transmitter on-chip retries.
4528 Both Transmit message failed due to too many retries.
4530 Both Transmit frames with alternate rate.
4532 Both Transmit frames with no ACK marked (broadcast, multicast).
4534 Both Management frames transmitted
4536 Both Transmit frames with RTS enabled.
4538 Both Transmit frames with CTS enabled.
4540 Both Beacons transmitted.
4542 Both Beacon missed count.
4544 Both Beacon miss reset count.
4546 Both Transmit message failed due to no TX buffer (data).
4548 Both Fatal hardware error interrupts.
4550 Both Receiver PHY error summary count.
4552 Both Transmitter queue stopped because it is full.
4.10 Utilities
ping
Ping is a basic Internet program that lets you verify that a particular IP address exists and can accept requests.
Ping is used diagnostically to ensure that a host computer that you are trying to reach is actually operating. For
example, if a user can not ping a host the user will be unable to send files to that host. Ping operates by sending a