KAROLINA Quick-start guide 1 ON/OFF button 2 FAN button 3 MODE button 4 +/- button 5 TURBO button 6 button 2 2 5 4 11 3 9 1 13 6 4 3 8 10 12 14 16 7 7 8 CLOCK button 1 9 TIMER ON/ TIMER OFF button 10 TEMP button 15 11 (before opening cover button (after opening cover / button 12 I FEEL button 1 ON/OFF button 13 LIGHT button 2 FAN button 14 X-FAN button 3 MODE button 15 QUIET button 4 +/- button 16 SLEEP button I feel Quiet Set fan speed Turbo mode Send signal Healthy mod
Introduction for buttons on remote controller Note: ●This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the model don't have, if press the corresponding button on the remote controller that the unit will keep the original running status. ● After putting through the power, the air conditioner will give out a sound. Operation indictor " " is ON (red indicator).
Introduction for buttons on remote controller Presetting temperature can be decreased. Press this button, the temperature can be set up, continuously press this button and hold for two seconds, the relative contents can quickly change, until unhold this button and send the order that the ( ) signal will be displayed all the time. The temperature adjustment is unavailable under the Auto mode, but the order can be sent by if pressing this button.
Introduction for buttons on remote controller button, 2 seconds later, it quickly change, the way of change is: During the initial 2.5 seconds, ten numbers change in the one place of minute, then the one place is constant, ten numbers change in the tens place of minu te at 2.5 seconds speed and carry. During 5s blink, press the Timer button, the timer setting succeeds. The Timer On has been set up, repress the timer button, the Timer On will be canceled.
Introduction for buttons on remote controller 13 LIGHT button 14 X-FAN button 15 QUIET button 16 SLEEP button Press this button at unit On or Off status, Light On and Light Off can be set up. After powered on, Light On is defaulted. Pressing X-FAN button in COOL or DRY mode, the icon is displayed and the indoor fan will continue operation for 2 minutes in order to dry the indoor unit even though you have turned off the unit. After energization, X-FAN OFF is defaulted.
Introduction for buttons on remote controller (4) When setting the initial temperature 30°C, under this temperature setting, after 7hours, the temperature will be decreased 1°C, after that the unit will keep on running under this temperature; In Heat mode: (1) Under the initial presetting temperature 16°C, it will run under this setting temperature all along.
KEY FEATURES & FUNCTIONS DEFROST FUNCTION This increases room comfort and saves energy by sensing the need for defrosting and eliminating unnecessary defrost cycles. SLEEP MODE You design a cycle to automatically adjust room temperatures during your sleep time, to maximize comfort and reduce utility bills. TURBO MODE This capacity boost function is the fastest way to reach a desired temperature setpoint, either in heating or cooling.
66129923113