Installation Manual

15
6 INSTALLATION OF THE DECORATION PANEL
Detach the intake grille
panel.
- Slide the 2 grille hooks toward the middle of the decoration
Install the paneldecoration
- Align the indicated triangle on the
triangle on the unit.
decoration
panel to the indicated
- Attach the
panel to the unit with the supplied screws,
as shown in the figure below.
decoration
1 Intake grille
2 Grille hook
- Open the intake grille and remove.
1 Decoration panel
2 Screws (M5) (supplied with the panel)
- After installing the decoration panel, ensure that there is no
space between the unit body and the decoration panel. If
there is, air may leak through the gap and cause dewdrop.
(See the figure below.)
Fasten the control box lid with 2 screws
1
2
×
√
1
2
Connect the 2 wires of the decoration panel to the
mainboard of the unit
10-core wire
5-core wire
Mount the intake grille
Ensure that the buckles at the back of the grille are properly
seated in the groove of the panel.