Product Guide

21
www.eaton.com/wireless
call toll free: 1-800-663-8806 DMAN-4096-01 R1
Service Mode: Field Configuration (continued)
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Solid
Green
Solid
Red & Green
Alternating
Yellow
Solid
NOTE: If left idle in Setup Mode for over 30 seconds, the receiver will time out. The (Link) light and (Status) light will flash RED rapidly. To return
to Setup Mode, repeat step 4.
A. Press & hold [Setup] button
until (STATUS) light goes
from slow flash to fast flash
B. Release [Setup] button.
(STATUS) light goes to
solid GREEN, (LINK) light
turns off
ESTOP
FAULT LINK
STATUS
Setup
Button
A.
ESTOP
FAULT LINK
STATUS
Setup
Button
B.
4. Put R160 into Setup Mode
ESTOP
FAULT LINK
STATUS
A. Press the green button on the TS110 once to
accept.
Pairing with the Base Station will commence.
B. Once the Code has been downloaded, the
(Link) light on the receiver will change from
GREEN to RED.
5. Send Code
NOTE: After the full Configuration Code sequence has been entered, the TS110 will blink out what was entered for con-
firmation. If there was a mistake, the Configuration Code may be re-entered. The code will only be accepted if
the full sequence has been entered and the green button is pressed.