Product Guide

www.eaton.com/wireless

call toll free: 1-800-663-8806 DMAN-4096-01 R1

Reprogramming Tips:

1. Be patient and deliberate when pressing the Power and E-Stop buttons in the correct order during power up in Con-

figuration mode

2. Follow each step as laid out in the procedure

Considerations when Pairing

Potential downloading issues

If the testing of the RCU and the Base Station both show the system as working (Chart 1 & 2), then the RCU and

Base Station will both go into Pairing/Configuration mode.

Possible issues could arise during Step 3, the teaching phase of pairing. In this case there are 2 symptoms to look

for:

1. The Link light on the Base Station will not turn GREEN when the power switch is toggled on the RCU to

download

2. The Base Station will “time out” indicating that it didn’t receive a signal from the RCU within the 30 sec-

onds from the time the Base Station was put into Setup Mode.

If all indications appear normal during the pairing phase, test the link by turning on the RCU (Note: the RCU remains in

Service Mode after pairing in Step 3).

1. If the Link light on the Base Station doesn’t turn GREEN, the Base Station didn’t receive all of the information that

was sent from the RCU.

Possible Solutions

1. Try the Downloading steps again

2. If this doesn’t correct the problem, send both the RCU and Base Station in for service.

Troubleshooting Guide (continued) Chart #3

NOTE: If possible try to determine whether the fault lies with the RCU or Base Station by completing the Re-

programming procedure with a different RCU. If this step works, then the fault lies with the original

RCU. If not, the fault may lie with the Base Station.