User's Manual

1 1 Introduction

The XPD2400 transceiver module is not sold separately as a standalone device. It is intended

to be used as part of a complete Cooper Industries (Electrical) Inc remote control device and in

the user manual for any device containing the module will be included the text from the following

paragraph.

This manual is for the use of professionals to guide them in the installation, operation and basic

system maintenance of the equipment covered.

The XPD2400 radio module has been certified for the FCC and ISED as a portable single-

modular transmitter. The XPD2400 PCB revision 5 radio module has the FCC ID: IA9XPD2400A

and the ISED certification number: 1338B-XPD2400A.

2 List of Applicable FCC and ISED Rules

The following FCC rules are applicable to the transmitter: FCC Title 47 CFR Subpart C Part

15.203, Part 15.247, Part 15.205(a), Part 15.209(a) & 15.247(d) and 15.33(a)(1)..

The following ISED rules are applicable to the transmitter: RSS-Gen Issue 5 Section 7.1.2,

RSS-247 Issue 2 (5.1) (a), (b) and (c), RSS-Gen Issue 5 (8.9), (8.10).

3 Specific Operational Use Conditions

The radio module may be used only with the antennas that were certified with the module. Using

a different antenna is possible only if a Class II Permissible Change is approved.

4 Limited Module Procedure

There aren’t limiting conditions on the module that require a host device to remedy. The radio

module meets all the eight requirements in FCC Part 15.212(a)(1) for modular approval.

5 FCC and ISED Regulatory Statements

The host products that integrate the radio module will include the following statements in their

user manual.

5.1 FCC Part 15 Statement

In accordance with FCC rule 15.21 and requirements 15.19(a)(5), the following statement shall

be included in the user manual.

FCC Part 15

This device complies with FCC Rules Part 15 operation is subject to the following two

conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference, including interference that may cause

undesired operation of the device.

Changes or modifications to this device, not expressly approved by Cooper Industries

(Electrical) Inc. could void the user’s authority to operate the equipment.

5.2 ISED Statement

In accordance with the requirement of RSS-GEN 8.4, the following statement shall be

included in the user manual.

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject

to the following two conditions: