Manual

CF 66 53 Rev. C 2/05
500. HERTZ 2 ±4000 ±2500
800. HERTZ 2 ±2500 ±2500
POWER-ON SOURCE Menu Item
This menu selects which value is displayed by the channel when first entering the RUN mode.
The choices are:
• “TRACK” means the live tracking value of the channel.
• “PEAK” means the highest value of the channel
• “VALLEY” means the lowest value of the channel
• “TRACK/PEAK” means the live tracking value and the highest value of the channel. (Only available on DFI
SC3004)
• “TRACK/VALLEY” means the live tracking value and the lowest value of the channel.
• “PEAK/VALLEY” means the highest and lowest values of the channel. (Only available on DFI SC3004).
12.6.2 DISPLAY SETUP Sub-Menu
This menu controls how data values are displayed by the channel and transmitted via serial communications.
DISPLAY.DIGITS Menu Item
Selects the number of digits displayed by the channel. The choices are:
• “5 DIGIT-BIPOLAR” displays both positive and negative numbers with five full digits (±99999).
• “6 DIGIT-UNIPOLAR” displays positive numbers with six full digits (999999) and negative numbers with five full
digits (-99999).
• “7 DIGIT UNIPOLAR” displays positive number with seven full digits (9999999) and negative numbers with six
digits (-999999).
DISPLAY.DECPT Menu Item
Selects the decimal point location on the channel’s display and serial communications output. Use the [UP] and
[DOWN] buttons to move the decimal point to the right and left.
This menu item may be automatically updated by a transducer’s Signature Module.
DISPLAY.COUNT-BY Menu Item
Determines by what value the display increments or decrements. This will make the display less sensitive to a
noisy signal. The choices are:
• “00001”
• “00002”
• “00005”
• “00010”
• “00020”
• “00050”
• “00100”
• “00200”
DISPLAY.UNITS Menu Item
Specifies the four-character label that is displayed to the right of the channel’s values.
This menu item doesn’t change the mathematical scaling of the channel’s values; that can be changed by altering
the “CALIBRATION DATA->FULL SCALE VALUE” menu item and then performing a re-calibration.
When a character position is flashing press the [UP] and [DOWN] button to change the character. Press [ENTER]
to advance to the next character.
DISPLAY.AVERAGE Menu Item
Controls the speed with which the channel’s display values will update. Display averaging does not affect the
channel’s analog output or its peak/valley detection, which will proceed at the speed selected by the “OPERATION-
>FREQ.RESPONSE” menu item. The choices are: