Instruction Manual

SPAN TEMPCO: less than 20 ppm/°C
STEP RESPONSE: 1 second to 99.9%
WARMUP: 55 minutes to rated accuracy It is recommended that the unit be continuously
running to insure its accuracy.
CONVERSION TECHNIQUE: Dual-slope
READRATE and DISPLAY
UPDATE/Programmable
INTEGRATION TIME: 3 samples/sec: 100 msec
13 samples/sec, 60 Hz: 16.7 msec
12 samples/sec, 50 Hz: 20 msec
DISPLAY LEDs: 6, 0.54" (13.8mm)h, red, 14-segment
4, 0.12" x 0.24" (3 x 6mm), red lamp
SYMBOLS: –.8.8.8.8.8. or 8.8.8.8.8.8.
DECIMAL
POINT POSITION:
Programmable
SENSOR EXCITATION
AC-POWERED: 1.5 to 11Vdc, up to 60 mA max.
24 Vdc at 25 mA max.
DC-POWERED: 10Vdc at 120 mA.
24Vdc at 35 mA.
Can power up to 4 load cells.
OUTPUTS
(STANDARD): 4, isolated open collector; 150 mA at 1 V sink; 30 V open
BCD OUTPUT: Tri-state, TTL/CMOS compatible; internal 5 V supply for non-isolated, external
5 V supply for isolated.
ANALOG OUTPUT: 0-5 V, 1-5 V, 0-10 V, 0-20 mA, 4-20 mA level; compliance, 12 V at 20 mA; 15-
bit resolution; 0.1% accuracy; programmable zero and span.
RELAY OUTPUT:
POWER RATINGS FOR
RESISTIVE LOADS:
DUAL AND 4 RELAY:
4 RELAY ONLY:
Dual Form-C relays or 4 Form-C relay
Two relays at P6 and P7
Normally open contact, 7 amp; 30 Vdc or 230 Vac
Normally closed contact, 7 amp; 30 Vdc or 230 Vac
Two relays at P18
Normally open contact 1 amp; 24 Vdc or 30 Vac
Normally closed contact, 1 amp; 24 Vdc or 30 Vac
TURNDOWN RATIO
(MAX OFFSET-MIN
SPAN):
1000 with 0.1% or 100 with 0.01% resolution
COMMUNICATIONS
INFORMATION
RS-232
COMMUNICATIONS:
RJ11 4-wire connection; complete program setup and message display
capability; programmable to transmit current display, alarm status, MIN/MAX,
and status
BAUD RATES: 300, 600, 1200, 2400, 4800, 9600, 19200
RS-485 COMMUNICATIONS: RJ12 6-wire connection; addressable from “000” to “199”.
BAUD RATES: 300, 1200, 2400, 4800, 9600, 19200
POWER
∼ AC UNITS:
115/230 Vac + or -10%, 50/60 Hz; 12 W max power consumption
= DC UNITS: 10-32Vdc, 3 to 9 W consumption
CF 67 71 M1291/N/0403 11279ML-02 Rev. A