Instruction Manual

DURING SETPOINT ADJUST (RUN MODE)
OUT OF SELECTED DIGIT RANGE: “999999”
NOT STORED IN EEPROM: “NOSTOR”
VALUE PUT IN EEPROM: “STORED”
19.0 FACTORY PRESET VALUES
JUMPER POSITIONS:
ac Powered unit
S1: NONE S2: A, F, L, N, T
S3: A, C S4: A, C
dc Powered unit
S1 (dc power board A
S1: NONE S2:A F, L, N, T
S3: A, C, D S4: A S5: A
LOCKOUT CONFIGURATION (VS)
L1 CNF L2 CNF L3 CNF L4 CNF
L1C.1=0 L2C.1=0 L3C.1=0 L4C.1=0
L1C.2=0 L2C.2=0 L3C.2=0 L4C.2=0
L1C.3=0 L2C.3=0 L3C.3=0 L4C.3=0
L1C.4=0 L2C.4=0 L3C.4=0 L4C.4=0
L1C.5=0 L2C.5=0 L3C.5=0 L4C.5=0
L3C.7=0
Input Type:
(“RDG SC”): 1.00000
INP.1=0
INP.6=0
INPUT 1: 000000.
READ 2: 100000.
Filter Configuration “FIL.CNF”: FIL.1=0 FIL.2=1 FIL.3=1
ALC.3=1
ALC.7=0
ALF.1=0
Alarm Number of Readings “AL RDG”:
L1C.6=0 L2C.6=0 L3C.6=0 L4C.6=1
L1C.7=0 L2C.7=0
L1C.8=0 L2C.8=0 L3C.8=0
Input Class:
Strain Gage: “BRIDGE”
0-100 mV
Reading Configuration “RDG.CNF”:
RDG.1=0 RDG.2=0 RDG.3=0 RDG.4=0
RDG.5=0 RDG.6=0 RDG.7=0
Reading Scale
Reading Offset
(RDG OF”): -000000
Input Configuration “IN CNF”:
INP.2=0 INP.3=0 INP.4=0
INP.5=0 INP.7=1
Input Scale and Offset “IN.SC.OF”:
READ 1: 000000.
INPUT 2: 100000.
Decimal Point “DEC PT” Position: FFFFFF.
Count By “CNT BY”: 001
Filter Time Constant “FIL TI”: 064
Setpoint Configuration “SP CNF”:
SPC.1=0 SPC.2=0 SPC.3=1 SPC.4=0
SPC.5=0 SPC.6=1 SPC.7=0 SPC.8=0
Alarm Configuration “AL CNF”:
ALC.1=0 ALC.2=0 ALC.4=0
ALC.5=0 ALC.6=1 ALC.8=0
Alarm Function “AL FNC”:
ALF.2=0 ALF.3=0 ALF.4=0
03 03 for (AL1) (AL2)
CF 67 73 M1291/N/0403 11279ML-02 Rev. A