Instruction Manual

Setpoints 1 & 2 Deadband “SP DB”: 0020
Alarms 1 & 2 Deadband “AL DB”: 0020
OUT.4=0
OUT.6=0
Output Scale and Offset “OT.SC.OF”:
Bus Format “BUS FT”:
BUS.2=0
BUS.6=0
Serial Count “SERCNT”: 00001
Output Configuration “OUT.CNF”:
OUT.1=0 OUT.2=1 OUT.3=0
OUT.5=1
READ 1: 000000. OUTPT 1: 04.0000
READ 2: 100000. OUTPT 2: 20.0000
Baud Rate “BAUD”: 09600
Serial Communication Configuration “SERCNF”:
SER.1=1 SER.2=0
Address “ADDRES” (for RS-485): 001
Data Format “DAT FT”:
DAT.1=0 DAT.2=0 DAT.3=1 DAT.4=0
DAT.5=0 DAT.6=0 DAT.7=0 DAT.8=0
BUS.1=0 BUS.3=1 BUS.4=0
BUS.5=1 BUS.7=0 BUS.8=1
ANALOG OUTPUT
CAL VZ:
CAL VS:
CAL mAZ:
CAL mAS:
20.0 RECORD YOUR SETUP VALUES
JUMPER POSITIONS:
Current
S1: _______ S2: ___________
S3: _______ S4: ___________
Voltage
S3: _______ S4: ___________
Potentiometer
S3: _______ S4: ___________
L4 CNF
L4C.1=___
L1C.2=___
L1C.4=___ L4C.4=___
L3C.5=___
L3C.8=___
Input Type:
S1: _______ S2: ___________
S1: _______ S2: ___________
LOCKOUT CONFIGURATION(S)
L1 CNF L2 CNF L3 CNF
L1C.1=___ L2C.1=___ L3C.1=___
L2C.2=___ L3C.2=___ L4C.2=___
L1C.3=___ L2C.3=___ L3C.3=___ L4C.3=___
L2C.4=___ L3C.4=___
L1C.5=___ L2C.5=___ L4C.5=___
L1C.6=___ L2C.6=___ L3C.6=___ L4C.6=___
L1C.7=___ L2C.7=___ L3C.7=___ L4C.7=___
L1C.8=___ L2C.8=___
Input Class: “BRIDGE”
For Current: ________
For Volt: __________
CF 67 74 M1291/N/0403 11279ML-02 Rev. A