Manual

CF 187 6 RevA
5.0 CONFIGURATION AND CALIBRATION VIA TOOLKIT SOFTWARE
**This section is only necessary for changing the default operation characteristics of the
MasterLink 3000 or for calibrating a strain gage transducer to a MasterLink 3000 and linking to
various data display units (DDU). If a system has been purchased, the applicable DDU's have
been setup to the MasterLink 3000 amplifier. The MasterLink 3000 USB unit must be used for
calibration of a strain gage transducer. Cooper Instruments can perform a yearly calibration or
the customer can purchase the USB module to perform in-house calibration.
5.1 Utilizing the Toolkit Software for setting up a MasterLink 3000 amplifier
Goto Start -> Program Files -> T24 Toolkit and click on "T24 Toolkit" in the folder
Upon startup the following screen will be shown
The "Pair" button is used to link the MasterLink 3000 amplifier, the MasterLink 3000 Handheld,
and the MasterLink Analog Output to the MasterLink 3000 USB module. This is a one-time step
necessary to configure the relative device.
**THE TOOLKIT SOFTWARE WILL AUTOMATICALLY CONNECT TO THE USB MODULE AS
LONG AS THE USB MODULE IS CONNECTED TO THE COMPUTER