SERIES TSF/TSFM500/TSFH/TSFM500H TEST STANDS USER’S GUIDE http://www.cooperinstruments.
LIST OF INCLUDED ITEMS Item Force measurement test stand User’s Guide Base Mounting leg Column cap 5/16-18 x 1” screw for base installation 1/4-20 x 3/4" screw for top cap installation Thumb screw for gauge mounting Mounting hole drill template Attachment kit – includes three hooks (small, medium, and large), 2” and 3” diameter compression plates, and two couplers (#10-32 and 5/16-18) Tool kit Quantity TSF/ TSFH/ TSFM500 TSFM500H 1 1 1 1 1 2 1 2 4 2 4 4 4 1 1 1 1 1 UNPACKING AND SETTING UP 1.
After the two 5/16 screws holding the stand are tight, place the belt cover back into place. While making sure that there is no contact with the fine adjustment knob, tighten the screws in the four corners. With the base removed, the test stand can be easily integrated into large systems such as production lines. In general, the stand can be mounted on any angle (upside down, for example), although extra care should be taken during installation and operation.
POWER SWITCH Use this switch, in the left rear of the Control Unit, to turn on and turn off power to the test stand. Power is indicated by an amber light on the face of the Control Unit. POWER PLUG RECEPTACLE Located in the left rear of the Control Unit. Plug the power cord in here. CONTROL CABLE Plug this cable into the lower male connector on the test stand, adjacent to the motor.
TSF/TSFH OPERATION 1. Mount the test stand to a firm, flat, and level working surface for maximum safety and accuracy using four 5/16 screws (not included). Use the included mounting hole drill template (vertical model only) to accurately drill the holes. Testing can take place without securing the test stand in such a manner, however, it is strongly recommended that the stand be secured, especially for large forces. 2. Install a force gauge onto the gauge plate with four thumbscrews.
DIMENSIONS IN [MM] WARRANTY REPAIR POLICY Limited Warranty On Products Any Cooper Instruments product which, under normal operating conditions, proves defective in material or in workmanship within one year of the date of shipment by Cooper will be repaired or replaced free of charge provided that a return material authorization is obtained from Cooper and the defective product is sent, transportation charges prepaid, with notice of the defect, and it is established that the product has been properly insta
one year. The replacement warranty detailed here is the buyer’s exclusive remedy, and will satisfy all obligations of Cooper whether based on contract, negligence, or otherwise. Cooper is not responsible for any incidental or consequential loss or damage which might result from a failure of any and all other warranties, express or implied, including implied warranty of merchantability or fitness for particular purpose. Any unauthorized disassembly or attempt to repair voids this warranty.
