Programming Manual

90
WaveLinx User Manual
www.eaton.com/wavelinx
Step 8: Next, tap on the sensor icon. In the available sensors list, locate the sensor with the name/ descriptor identified earlier in this
procedure. Drag and drop the identified sensor into the assigned sensor section.
Tap sensor
Drag and drop identified
sensor into assigned sensors
Step 9: Tap on the back button to go back to the main daylight sets screen then repeat the procedure if additional daylight sets are needed.
Configure the additional
daylight set(s)
Tap the back button
to save and exit
Tap the plus sign
ote:N Once the zones and sensor are assigned to the daylight set, the daylighting will begin to operate per the hard coded parameters. It is possible to use the
calibrate tab to view the sensor’s current reading. The sensor reading will be located in the middle of the calibrate page and may be switched between reading
in lux or foot-candles. All other controls will not function for this sensor type.