Programming Manual

10
WaveLinx User Manual
www.eaton.com/wavelinx
WaveLinx Outdoor Integrated Sensor LED in sensor window should blink green with motion
detection. The green LED color indicates that the
integrated sensor has not yet been paired with a
Wireless Area Controller.
(If the LED blinks white, this indicates that the sensor
has been previously paired with a Wireless Area
Controller. See page 135 for information on resetting
the pairing.)
Fixture operates via the onboard daylight and
occupancy sensors.
• ON at dusk / OFF at dawn
• If fixture is ON at dusk, the occupancy sensor
determines the light level.
• If occupied, the fixture will go to 100%.
• The fixture will dim to 50% within 15 minutes
when the space is unoccupied.
WaveLinx Tilemount Sensor
LED in sensor window should blink green with motion
detection. The green LED color indicates that the
integrated sensor has not yet been paired with a
Wireless Area Controller.
(If the LED blinks white, this indicates that the sensor
has been previously paired with a Wireless Area
Controller. See page 135 for information on resetting
the pairing.)
Fixture operates via the onboard occupancy sensor
which can later be disabled during configuration.
• Occupancy turns connected 0-10V dimmable
fixture ON to 75%.
• Fixture will turn OFF within 20 minutes when
space is vacant.
Note: Daylighting is disabled until the fixture is
assigned to an area using the WaveLinx Mobile
Application.
WaveLinx Ceiling Sensor
LED may flash red once approximately every 10
seconds indicating that the unit is powered.
This device does not have out-of-the-box functionality
and will not operate until it is successfully paired
with a Wireless Area Controller.
WaveLinx Wireless Outdoor Lighting Control Module
Not applicable. The WaveLinx Wireless Outdoor
Lighting Control Module has no onboard LED
indicators.
Fixture turns ON to 100% upon power up and then
after a short evaluation period begins operation
from the onboard daylight sensor. The fixture will
then switch ON at dusk or OFF at dawn based on the
daylight sensor and availability of daylight until the
device is paired with the Wireless Area Controller.
WaveLinx Wallstation
If a button is pressed, the LED on that button will flash
slowly for approximately 10 seconds and then stop.
This device does not have out-of-the-box functionality
until it is successfully paired with a Wireless Area
Controller.