Programming Manual

112
WaveLinx User Manual
www.eaton.com/wavelinx
Renaming the Wireless Area Controller
Each Wireless Area Controller has a default name that will appear in the WaveLinx Mobile Application. It is possible to change this name
through the internal webpages.
To change the Wireless Area Controller default name:
Step 1: Establish a connection from the computer and the Wireless Area Controller as the administrator user.
Step 2: In the system page, locate the Wireless Area Controller name field and type in the desired name. Select the set name button to save
the change. The system will display a success message at the top of the screen to acknowledge the change. The new name will display in
the WaveLinx Mobile Application.
Type desired wireless
area controller name
Verify success
The new name will be
displayed in the mobile
application
Select the set name option
Performing a System Backup
Perform system backups regularly. The system should be backed up:
•
Once the system is initially running and operational
•
Before making significant changes
•
Before updating Wireless Area Controller or device firmware (suggested)
•
After updating Wireless Area Controller or device firmware (suggested)
The system may be restored from the backup if programmed changes do not operate as intended or if replacing the Wireless Area Controller
in the event of a controller failure.
To create a backup:
Step 1: Establish a connection from the computer and the Wireless Area Controller as the administrator user.
Step 2: In the system page, scroll down the screen, and then select the option to create and download backup file.