Programming Manual

13
WaveLinx User Manual
www.eaton.com/wavelinx
4: Place devices into pairing mode. See the below chart for information on how to place specific devices in pairing mode:
Device Type How to place pairing mode
WaveLinx Wireless Dimming Switchpack
(WSP-MV-010: 120-277VAC model)
Cycle the power (switch OFF and then ON) of each identified circuit using the circuit breakers. This places the
devices into pairing mode and starts their search for a Wireless Area Controller. Pairing mode automatically
times-out after 60 minutes if a device does not successfully pair with a Wireless Area Controller. Only unpaired
devices will enter pairing mode on the power cycle.
Note: Standard WaveLinx Wallstations (line voltage powered) will also respond to this pairing technique.
WaveLinx Integrated Sensor
WaveLinx Tilemount Sensor
WaveLinx Industrial Integrated Sensor
WaveLinx Outdoor Integrated Sensor