Programming Manual

133
WaveLinx User Manual
www.eaton.com/wavelinx
WaveLinx Battery Powered
Wallstations
When a button is pressed, no
button LEDs illuminate.
• Out-of-the-box, this is the correct behavior.
When my hand is in proximity
to the wallstation, the red LED
under the bottom button does
not flash.
• Verify that the batteries are installed properly for the wallstation and that they are fully charged.
• Verify that your hand is within approximately 5cm of the wallstation.
• Contact technical support if the problem persists.
When the button is pressed, the
LED on the button illuminates
then turns OFF. When I have my
hand close the station, the LED
on the button turns ON again.
• The wallstation has been previously paired and is part of either a construction group or mobile
application defined area. If paired with the incorrect Wireless Area Controller, locate the
controller that is responding to the button presses. Then, use the mobile application to identify
and delete the device manually from the incorrectly paired Wireless Area Controller to allow
pairing to the correct controller.
• The LEDs will turn OFF automatically to the conserve battery life conserving energy until the
wallstation is used again.
WaveLinx Receptacle
The outlet LED does not
illuminate and there is no power
on both outlets.
• Verify that the circuit wiring is properly connected and energized.
• Contact technical support if the problem persists.
The outlet LED does not
illuminate and there is no
power to the controlled outlet.
The constantly powered outlet
is operational.
• Press the onboard manual push button to try to toggle the LED and outlet state.
• If the problem persists, contact technical support.
Pairing mode timed out before I was done adding my battery powered ceiling sensors or before I confirmed my devices paired
properly. What should I do?
Simply press the PAIR button on the Wireless Area Controller again to re-establish pairing mode. All paired devices that are in the
construction group will respond with the paired behavior and additional devices may be added. Review the chart on page 15 for more
in-depth information on confirming paired behavior.
One or more of my devices did not pair to the controller or does not appear in my mobile application. What should I do?
First verify that the device still exhibits the proper out-of-the box behavior described on page 9. If it is not displaying the proper behavior,
refer to the troubleshooting chart on page 131 to determine the cause before proceeding.
If the device is exhibiting the proper behavior press the PAIR button on the Wireless Area Controller and then place the device into pairing
mode per the table on page 13. If the device still does not pair properly, verify that the distance is within the expected range and that there
are fewer than 200 devices paired to the Wireless Area Controller before contacting technical support.
I have more than one Wireless Area Controller in my facility. A device or multiple devices paired with the wrong controller.
How do I resolve this?
First ensure that you have performed the steps to connect to the Wireless Area Controller from the mobile application. Then organize all the
devices that should be paired with this Wireless Area Controller into the correct areas and zones. After the devices are assigned, remaining
devices will appear in the all unassigned device section of the mobile application and will still be assigned to the default construction area.