Programming Manual

134
WaveLinx User Manual
www.eaton.com/wavelinx
To remove a single device
For a single device, select the device to open the device screen, then select the trash can icon and confirm the deletion. Then, pair the
device with the correct Wireless Area Controller.
Select the device to remove
Select the delete icon
Confirm device
removal
To remove multiple devices
Remove all devices still assigned to the default construction group by pressing and holding the PAIR button on the Wireless Area Controller
for 4 seconds. Then, go through the pairing process to pair the devices with the correct Wireless Area Controller. Note that this command
will only affect devices that are still in the default construction area.
My device is showing paired behavior but it is not paired with the correct controller. I am unable to find what controller it has
paired with. How do I remove its pairing to start over?
Each device has the ability of being removed from pairing by a specific sequence. The remove pairing sequence should only be used as a last
resort. Please be aware for devices requiring power cycle sequences to remove pairing, if there are other like devices on the same circuit,
the power cycle sequence will remove pairing for ALL devices that respond to this clear sequence. Use with caution!