Programming Manual

14
WaveLinx User Manual
www.eaton.com/wavelinx
WaveLinx Wallstation Press any button on the Wallstation to initiate a PAIR request from any unpaired wallstation.
• On the standard WaveLinx Wallstation (line voltage powered), the LED on the button pressed should flash
slowly for approximately 10 seconds.
• On the WaveLinx Battery Powered Wallstation, the red LED below the buttons may flash briefly when the
proximity sensor detects someone near and may flash intermittently during the pairing process. No other
feedback from button LEDs will occur.
WaveLinx Wallstation Battery Powered
WaveLinx Wireless Outdoor Lighting Control Module If in an unpaired state, these devices will automatically pair when they receive the Wireless Area Controller
PAIR mode signal. The search command re-initiates every 20 minutes until a pair forms. A power cycle to these
devices will cause the search to start again approximately 20 seconds after the initial power up.
WaveLinx Wireless Dimming Switchpack
(WSP-CA-010: 120-347VAC model)
WaveLinx Ceiling Sensor Within the 60 minute pairing period, use one of the following methods to place each of the Occupancy Sensors
into PAIR mode:
• (Preferred method) Press the wireless PAIR button onboard the sensor to initiate the pair process.
• Shine a bright flashlight into the lens of each battery powered ceiling sensor to place the sensor into
PAIR mode.
• Motion activity may also trigger the sensor into PAIR mode although this method is less reliable.
The LED in the sensor window will flash ON and OFF for 10 seconds to indicate it is in pairing mode before
going back to its normal blink pattern.
WaveLinx Receptacle
Within the 60 minute pairing period, at each receptacle location, press and hold down the manual push button
for 5 seconds and then release the push button when the LED starts flashing red.
(Note: The LED may flash red or cycle between green and amber during the pairing process).
ote:N During the 60 minute pairing period, devices may exhibit paired behavior. It is possible to confirm successful WaveLinx device pairing by verifying that
each device’s exhibits this behavior. It is also possible to confirm pairing after the pairing process is complete. Refer to the chart below to see a device’s
expected behavior during initial pairing.