Programming Manual

16
WaveLinx User Manual
www.eaton.com/wavelinx
WaveLinx Tilemounted Sensor Paired device behavior:
Connected 0-10V dimmable fixtures dim to 10%.
LED in sensor window should blink WHITE with motion
detection.
WaveLinx Ceiling Sensor Not applicable for this device. Not applicable for this device.
WaveLinx Wireless Outdoor Lighting Control Module Paired device behavior:
Fixture dims to 10%.
WaveLinx Wallstation standard line voltage powered Paired device behavior:
All button LEDs will flash in a top to bottom the
bottom to top pattern until pairing mode is exited.
WaveLinx Battery Powered Wallstation Paired device behavior:
There is no immediate feedback that pairing was
successful. Refer to method 2.
Ensure that the Wireless Area Controller is not
in pairing mode. Then, press any button on the
wallstation. All lighting and receptacles paired with
the Wireless Area Controller and still in the default
construction area will respond to the command.
WaveLinx Receptacle Paired device behavior:
All paired receptacles still in the default construction
area will turn OFF for 5 minutes. After 5 minutes, the
receptacles will turn back ON. If there are too many
receptacles to review in the 5 minute period, see
alternate method 2.
Ensure that the Wireless Area Controller is not in
pairing mode. Then, press the manual push button on
the receptacle (1 second press) to toggle the controlled
outlet. A successfully paired receptacle still in the
default construction area will flash its LED either
between red/OFF, or green/amber for a period of
approximately 15 seconds.
7: Repeat the procedures in this section for each Wireless Area Controller in the facility.
Using the Mobile Application to Pair Devices
The WaveLinx Mobile Application may be used in the pairing process as an alternative to pressing the PAIR button on the Wireless Area
Controller. Log in as the administrator user and open the menu to select the option to discover new devices, acknowledging the message
that appears. A pairing icon will appear at the top of the screen to indicate that they system is in pairing mode. Once pairing is complete,
access the menu and select the option to stop discovering devices to end pairing mode or allow it to time out automatically.
Acknowledge
Pairing Active icon
Enable pairing
Acknowledge
Cancel pairing