Programming Manual
32
WaveLinx User Manual
www.eaton.com/wavelinx
5: Next assign any wallstations and ceiling sensors to the area. While still in the area screen for the desired space, place the first device in
the room into identification mode as described in this section. Once the device is identified, drag and drop the identified device into the in
area device section of the screen. Repeat this step until all wallstations and ceiling sensors in the room are identified and assigned.
Drag and drop the identified device
into the in area device list
How to initiate identification mode for wallstations and ceiling sensors:
Device Identification Mode
WaveLinx Wallstation
WaveLinx Wallstation Battery Powered
Press any button on the desired wallstation to place it in identification mode.
Standard line voltage powered wallstation:
• All button LEDs should flash for approximately 15 seconds and devices in the construction area will respond
to the button’s command. In the mobile application the icon will begin flashing and will move to the far-left
of the unassigned device list
Battery powered wallstation:
• The LED on the button pressed may illuminate for approximately 3 seconds and devices in the construction
area will respond to the button’s command. In the mobile application, the icon will begin flashing and will
move to the far left of the unassigned device list.*
* Note: If multiple battery powered wallstations with the same button configuration are in the same area,
rename each wallstation as it is assigned to allow for easy identification for the later programming steps.
To rename the device, once the device is assigned, tap on the wallstation’s icon and use the pencil icon at
the top of the page to open the edit option. Name the station, then save the change.
WaveLinx Ceiling Sensor
A laser pointer or bright, focused beam flashlight is recommended for this step. Standing beneath the sensor,
shine the light directly into the sensor lens for 3-4 seconds. The ceiling sensor icon will begin flashing on the
mobile application screen and will move to the far-left of the unassigned device list.