Programming Manual

65
WaveLinx User Manual
www.eaton.com/wavelinx
Step 6: While still in the occupancy set screen, tap the zone icon. Touch and drag the zones to be controlled into the controlled zones
section. Touch and drag zones that should not be controlled into the area zones section.
Touch and drag zones that should
operate from this occupancy set into
the controlled zone section
Touch and drag zones that should
not operate from this occupancy set
into the area zones section
Step 7: Next, tap the sensors icon. Verify that the displayed sensors are correct. If the assigned zones consist of fixtures with integrated
sensors, the sensors will automatically be displayed. Ceiling sensors may need to be manually assigned. Touch and drag the desired ceiling
sensor from the in area device section into the assigned sensors location.
Select the sensors icon
Touch and drag any ceiling sensors that should operate in this
occupancy set into the assigned sensors section. Integrated sensors
will show automatically based on controlled zone assignment.
ote:N Although a ceiling sensor is able to be assigned to multiple occupancy sets, in most cases assign a ceiling sensor to one occupancy set to avoid
confusion.
Step 8: Repeat steps 3 through 7 for all necessary occupancy sets.