Programming Manual

73
WaveLinx User Manual
www.eaton.com/wavelinx
Step 3: In the area screen, tap on the zone that the controlled fixture is assigned to. If there are multiple fixtures in the zone, identify the
correct device by using one of the following methods:
•
Method 1: Using a laser pointer or flashlight, stand beneath the fixture and shine the laser pointer directly into the lens of the sensor for
3-4 seconds. The timing needs to be precise for the identification mode to respond. The LED in the sensor window will briefly flash violet
at the end of this 3-4 second period. In the mobile application, the device’s icon will move to the far-left and begin to pulse in the in area
device section. Note the name of the identified device.
•
Method 2: Within the zone screen, double tap a fixture’s icon to place the fixture into blink to identify mode for 15 seconds. Repeat with
additional devices until the desired fixture load is visually identified. Note the name of the identified device.
Tap on the fixture's zone icon
Identify the correct device using
one of described methods
Step 4: Tap on the identified device to open its device details page. Make note of its currently assigned closed loop daylight set. Tap the back
button to exit the screen, then tap back again to exit the zone screen.
Identify the
currently assigned
daylight set.