Programming Manual

WaveLinx User Manual

www.eaton.com/wavelinx

Step 5: In the area screen, select the gear icon in the upper-right corner to open the area menu and then select the daylight set option.

Select the gear icon to

open the area menu

Select the daylight

sets option

Step 6: Tap on the icon for closed loop daylighting. In the list of closed loop sets, locate the closed loop daylight set(s) associated with

the identified load(s). Either tap on the disable all function at the top of the list to disable daylighting for all sensors in the area or tap on a

colored circle on the right side of the screen until the circle turns red to disable the daylighting function for a particular fixture/device.

ote:N If needed, daylighting can be re-enabled by tapping the circle again. It will turn green indicating that daylighting is enabled.

Tap the link to open the

closed loop daylight sets

Tap the circle in the row of a device

to disable or enable that device

• Green: enabled

• Red: disabled

Tap enable all or disable all

to activate or deactivate all

closed loop sensors in the area

Step 7: Repeat these steps for any other areas as needed.