Programming Manual

78
WaveLinx User Manual
www.eaton.com/wavelinx
Step 7: Repeat these steps for other areas as needed for the application.
Calibrating and Modifying Light Levels for a Single Closed Loop Daylight Sensors
It is also possible to adjust the closed loop settings for an individual sensor. Open the area that the fixture is located in and then locate and
tap on the icon for the identified fixture load. Tap the closed loop daylight sensor option visible in the middle of the screen and then tap on
the link to open the daylight set. Once the daylight set is opened, use the calibration screen to adjust the daylighting as needed.
Tap the icon for the identified load
Select to view the
daylight sensor
Tap the link to open the
daylight set
Use the controls to adjust
to the desired light level
Quick Links for Common Questions
•
After I calibrated the sensors, I noticed that the light output is different for each fixture. Why is this occurring?
See the answer on page 139.
•
My lights over my desk appear to adjust to different dimming levels even through the daylight does not appear to change.
Why is this happening? See the answer on page 139.
•
My wallstation or occupancy sensor does not appear to operate during the day but seems to work at night. Why is this occurring?
See the answer on page 140.