Programming Manual

80
WaveLinx User Manual
www.eaton.com/wavelinx
Step 3: In the area screen, select the gear icon in the upper-right corner to open the area menu and then select the daylight set option.
Select the gear icon to
open the area menu
Select the daylight sets
option
Step 4: Tap on the icon for closed loop daylighting. A list of the outdoor fixture integrated sensors assigned to the area will appear. Ensure
that the sensors that need to perform daylighting are enabled (green circle) and then tap the button to calibrate all at the bottom of the
screen. The devices being calibrated will all go to their brightest light output.
Tap the link to open the
closed loop daylight sets
Tap the circle in the row
of a device to disable or
enable that device
• Green: enabled
• Red: disabled
Tap the option
to calibrate all
Step 5: Leaving all screen controls at the default settings, at the bottom of the calibration screen, click on the calibrate button. The current
light level of each of the affected sensor will then be stored as the target light level. The mobile application will show whether calibration was
successful. If failures are reported on this page, it will be necessary to repeat this procedure.
ote:N It is not necessary to adjust any of the level sliders in an outdoor application. Optionally, the work surface reading can be entered using a light meter for
reference to allow the current reading fields to more closely approximate what the light level is at the desired surface. This will have no effect on the calibrated
level other than for the current reading display purposes.