Programming Manual

85
WaveLinx User Manual
www.eaton.com/wavelinx
Step 10: Next, tap on the sensor icon. If multiple ceiling sensors are listed in the available sensors list, locate the sensor with the name/
descriptor identified earlier in this procedure. Drag and drop the identified sensor into the assigned sensor section.
Tap sensor
Drag and drop identified
sensor into assigned sensors
Step 11: Tap on the calibrate icon. Drag the adjustment slider to modify the zone’s dimming response. Lowering the adjustment bar will
lower the electric light level and increase the sensitivity to daylight. Raising the adjustment bar will raise increase the electric light level and
decrease the sensitivity to daylight. The system will automatically enter test mode when adjustments are made to accelerate response.
Tap calibration
Use the slider bar
to adjust dimming
response
Test mode will be enabled