Specifications

Owners Manual, Monaco 6000A, 6000N, 6002A, 6002N
6. Ballast & Lamp Module - Replacement Instructions
WARNING!
TURN OFF ALL POWER TO FIXTURE BEFORE
REPLACING BALLAST ASSEMBLY.
DO NOT OVERTIGHTEN CAPTIVE SCREWS ON THE
TRIM RING! SET POWER DRIVERS TO LOWEST
SETTING. THIS IS IMPORTANT TO AVOID DAMAGING
PARTS.
MATERIAL LIST
QTY
Ballast and Lamp Module Replacement Assembly 1
Submersible Wire Nuts (included) 3
Return address label 1
BALLAST AND LAMP MODULE REPLACEMENT
PROCEDURE
1) Loosen trim ring/lens assembly by loosening four socket
head cap screws.
2) Pry trim ring/lens assembly off housing by inserting a flat
head screwdriver in side slots and turning.
Remove trim ring/lens assembly.
4) Lift sealed lamp module from housing.
5) Disconnect ballast wires from incoming power by
removing wire nut connections in the
housing wiring box. (Discard wire nuts. New water-tight
water nuts, provided, must be used
for reconnection).
6) Disconnect ground wire from ballast to incoming power.
7) Lift ballast assembly out of the housing.
8) Disconnect strain relief from side of in-grade housing and
set the ballast to be replaced aside.
9) Unpack the new ballast/lamp module assembly and place
ballast in the housing with the wires
facing up.
NOTE: USE THE SAME BOX TO SEND A FAILED
BALLAST BACK TO LUMIERE FOR FAILURE
ANALYSIS. ALL RETURNS MUST BE
AUTHORIZED BY YOUR FIELD SERVICE
REPRESENTATIVE.
10) Set sealed lamp module assembly on the ground next to
housing.
11) There is a plastic strain relief attached to free wires
coming off ballast assembly. Attach strain relief to stud
of in-grade housing and reattach nut. See Figure 1.
12) Route wires through opening in side mounted wiring
compartment.
13) Connect the three color coded wires from ballast assembly to
incoming power wires.
NOTE: WIRES MUST BE CONNECTED USING THE
SUBMERSIBLE WATER-TIGHT WIRE NUTS
PROVIDED.
NOTE: THERE ARE TWO GREEN GROUND WIRES, ONE
FROM THE BALLAST ASSEMBLY AND ONE ON THE
HOUSING, WHICH MUST BE ATTACHED TO THE
INCOMING POWER GROUND.
14) Connect wires using water-tight wire nuts, as follows:
Strip wires from incoming power to ½”.
Align frayed strands or conductors.
Twist stranded wires slightly.
Insert wires together through sealant in wire nuts.
Hold wires firmly and twist wire nuts onto wires.
NOTE: Do not twist wire nuts too hard.
NOTE: Do not reuse wire nuts.
15) Carefully insert wires with wire nuts into side mounted
wiring compartment.
16) Carefully place lamp module into housing. Align two
notches in lamp module
hanging frame with two pins in the housing. See Figure 2.
Attach strain relief
from ballast
assembly here
Figure 1
Page 10 of 12 9700 B Owners Manual Monaco 6000.doc