Specifications

Owners Manual, Monaco 6000A, 6000N, 6002A, 6002N
Page 7 of 12 9700 B Owners Manual Monaco 6000.doc
INSTALL TRIM RING/LENS ASSEMBLY
12) Install trim ring/lens assembly by aligning four threaded holes
and attaching four socket head cap screws.
RELAMPING PROCEDURE
WARNING! TURN OFF ALL POWER TO FIXTURE BEFORE,
RELAMPING, MAINTENANCE AND SERVICING.
WARNING! RELAMP ONLY WITH SAME WATTAGE AND
TYPE OF LAMP ORIGINALLY SUPPLIED WITH FIXTURE.
SEE LABEL ON SIDE OF BALLAST BOX FOR CORRECT
INFORMATION.
13) Loosen trim ring/lens assembly by loosening four socket head cap
screws.
14) Pry trim ring/lens assembly off housing by inserting a flat head
screwdriver in side slots and turning.
15) Remove trim ring/lens assembly.
16) Lift sealed lamp module from housing assembly.
17) Remove lamp module sealing clamp by loosening screw on
clamp with a 3/16” Allen wrench. See Figure 4.
NOTE: Screw does not have to be removed
18) Remove lamp module sealing clamp by pulling it out and over
screw head. Then pull remainder of clamp free of assembly.
CAUTION: Do not bend clamp!
19) Remove optical accessory holder from top of lens.
20) Remove inner lens with rubber seal.
21) Replace lamp.
22) Verify that inside of lamp housing is clean and dry before
reassembly.
23) Verify that inner seal and lens are clean and dry before
reassembly.
24) Reassemble fixture in reverse order of disassembly.
Slotted screw
locks/unlocks orientation
lamp adjustment
Loosen this screw
to remove sealing
clamp
Figure 3
Lamp module
sealing clamp
Figure 4