Instruction Manual

Warning: FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user's authorization to
operate this equipment.
How to select your desired feature
Mode of Operation Slide switch position How to set power switch
Auto Setting
(motion activated)
Remote sensor detects motion and
sends an ON signal to receiver. Lights
should turn off after 4 or 12 minutes
after all motion stops. The transmitter
contains a daylight sensor, which only
allows lights to come on at night.
4 MIN
Or
12 MIN
Keep the power to the receiver
on.
Manual Override
Lights should stay on continuously. It
will reset to TEST or AUTO setting
after 4 hours or you can reset manually
by turning power off for 5 seconds and
back on.
TEST
4 MIN
Or
12 MIN
Turn power to the receiver off
for 2 seconds and back to the ON
position.
TEST Setting
Lights should turn on when the remote
sensor detects motion, both day and
night. Lights should turn off after 8
seconds after all motion has stopped.
TEST
Keep the power to the fixture on.