Programming Manual

137
WaveLinx User Manual
www.eaton.com/wavelinx
I am done assigning my devices to areas but I still have devices showing in my all unassigned devices list. What should I do?
If this is the only Wireless Area Controller in the facility, a device may have been added that is not shown on the plans. Connect to the
Wireless Area Controller using the mobile application. Then, open the device configuration and select the blink to identify option located at
the bottom of the screen. If the device is a standard ambient, industrial, or outdoor integrated sensor, a tilemount daylight sensor, a wireless
Dimming Switchpack, or wireless outdoor lighting control module the connected load will start turning ON and OFF repeatedly during a 15
second period. If the device is a standard line voltage powered wallstation, the button LEDs will flash for a 15 second period. If the device
is a receptacle, the LED on the receptacle will flash between green and amber if the outlet is ON or red and OFF if the outlet is OFF. Walk
around the space until the device is identified, continuing to refresh the blink to identify command as needed. Note that battery powered
ceiling sensors and battery powered wallstations do not have the option to blink to identify.
If there are other Wireless Area Controllers in the facility, the device may have paired with the incorrect controller. Follow the steps on page
133 to remove the device and to prepare it for pairing to the correct controller.
I installed a new device after I completed the initial construction pairing or I found a device that was not powered during the
pairing process. How do I pair the new device into the existing construction group?
To pair an additional device after the initial construction pairing is complete, press the PAIR button on the Wireless Area Controller to
reinitialize pairing and then place the device in pairing mode per the table on page 13. The device should join the existing construction group
within the 60 minute pairing process.
How do I switch users?
It is easy to change users in the mobile application. Simply select the menu icon at the top any screen, and then select the option to change
user. Log in as the desired user.
Tap on the menu icon
Select the change user option
When I open the mobile application, I get an error message. What should I do?
Review the displayed message. If it is a connection error, verify that the mobile device is still connected to the proper wireless network.
If it is not a connection error, shut down the application by double tapping the home button and closing it if using an iOS device, or close it
through the recent applications function on android devices. Disconnect and then reconnect to the correct wireless network, and then open
the application. Contact technical support if the problem persists.