Programming Manual

WaveLinx User Manual

www.eaton.com/wavelinx

How to initiate identification mode in controlled load devices:

Device Identification Mode

WaveLinx Integrated Sensor and

WaveLinx Tilemount Sensor

For fixtures mounted at reasonable mounting heights, use a laser pointer or bright, focused beam

flashlight to trigger identification mode. Standing beneath the sensor, shine the light directly into the

sensor lens for 3-4 seconds. The timing needs to be precise for the identification mode to respond. The

LED in the sensor window will briefly flash violet at the end of this 3-4 second period. The load icon will

begin flashing on the mobile application screen and will move to the far-left of the unassigned device list.

Note: If fixtures mounting height is beyond the range of the laser pointer or flashlight, use the blink to identify

feature to identify the devices. Refer to the next section in this chart for how to use this feature for high bay

and high mount fixtures.

WaveLinx Industrial Integrated Sensor

- Low bay mounting

WaveLinx Outdoor Integrated Sensor

- Low mounting height