User's Manual

Step 8: Install motion sensor head (A) on driveway sensor post (I) by align-
ing slots in flange on bottom of sensor head with protrusions on side of post
top.
NOTE: Make sure motion sensor front is in the same orientation as
arrow on post flange. Rotate sensor head clockwise until locked in place.
Lens of sensor head should be pointing toward desired detection area.
Mounting your light fixture (receiver)
Step 1: WARNING: Risk of electric shock.
Disconnect power at fuse or circuit breaker
before installing or servicing.
Step 2: This mounting plate has been
designed to work with a variety of different
junction boxes. Line up the knockout holes
in the mounting plate with the screw loca-
tions in your junction box. Drill out the
matching holes in the mounting plate, using an electric drill and a 1/8" drill
bit or knock out the hole with a punch and hammer.
Step 3: Take the gasket included with this mounting plate and position it
behind the mounting plate. Line up the screws in the mounting plate with
the appropriate hole pattern in the gasket and remove gasket material in
those holes. When wall mounting, locate arrow on back of mounting plate
and mount with arrow pointing up.
Step 4: Connect lampholder wires to supply wires from house (white to
white and black to black) using wire nuts included. No ground wire
required. Attach any ground wire from your house to the junction box.
Step 5: Attach the mounting plate to your junction box using screws includ-
ed, making sure that the gasket is properly aligned and that all screws are
tightly secured. To prevent moisture from entering the junction box, apply a
bead of silicone sealant around the edge of the mounting plate where it
attaches to the junction box.
Step 6: Turn power on at the main fuse/breaker box.
Aiming the light
Loosen the knob on the side of the lamp holder. Tilt lamp holder up or
down to desired position then retighten knob. Tilt lamp holders at least 15°
downward.
NOTE: Deviation from the assembly instructions may result in a
risk or electric shock.
How to operate your fixture
Step 1: Make sure motion sensor and remote light are
set to the same house code (fixtures will come from
factory already set to the same code). You may reset
the house code by turning the dial inside the battery
compartment of the driveway sensor head and the bot-
tom of the floodlight to the same number (N). There are
16 different selections
Step 2: Move slide switch inside battery compartment
of driveway sensor head to "TEST". Set sensitivity
knob to medium (halfway).
5
ENGLISH
N
Round Rectangular (horizontal) Octagonal
Your fixture mounts
to the following standard
junction boxes: