User's Manual

ManualsBrandsCooper Lighting ManualsElectronicsPIR Transmitter

Step 3: Turn on power to floodlight receiver.

Step 4: Aim driveway sensor head toward desired detection area.

Step 5: Walk across the detection zone at the farthest distance you wish

your detector to detect motion. Adjust sensitivity until you get desired results.

Step 6: Your sensor is equipped with two lens shutters,

which will allow you to customize your detection area

down to 90 degrees. If the sensor is seeing at too wide

of an angle, or if you wish to block certain areas from

being detected, you can do so by simply locating the

shutters on either side of the lens. Carefully pull the

shutter(s) out using the two tabs on the front of the shutter (O).

NOTE: Be

sure to use two fingers and pull the upper and lower tab simultaneously to

insure proper and even sliding. Each shutter will extend approximately 1-

1/2" to help prevent either side of the sensor from detecting motion.

Step 7: Move slide switch inside battery compartment to 4 MIN or 12 MIN

(AUTO mode). At dusk your lights will operate in the AUTO setting.

Step 8: Replace cover after all adjustments are made.

How to select your desired feature

ENGLISH

Auto Setting

(motion activated)

Floodlight will

automatically turn ON when

motion is detected by the

motion sensor, and will

remain ON for four or

twelve minutes after motion

has stopped.

Set slide switch to:

4 MIN

12 MIN

Make sure power

is on to the

floodlight.

Manual Override

Allows floodlight to be

manually turned ON and

used as a standard flood-

light. Light will stay on

for four hours.

Any position

Turn power to the floodlight

off for 2 seconds and back

to the ON position using

indoor wall switch.

Test Setting

This mode is used for

set up of fixture during initial

installation. It allows flood-

light to turn on both day

and night and stay ON for

eight

seconds.

TEST

Make sure power is on

to the floodlight.

Mode of

Operation:

Motion Sensor

(Transmitter)

Floodlight

(Receiver)

Reset Manual Override

To resume motion

activated mode.

To reset floodlight turn

power off for 10 seconds

and resume power for

motion activated mode.