User`s guide

18
Chapter 3: Troubleshooting
Alert Messages
This section gives the meaning of each
message that can be displayed when
resetting the system (page 15).
ALARM 0005
08:13:45 01/01
A zone alarm has occurred. The zone
number is displayed, together with the time
and date.
PSTN LINE FAULT
12:00 Sun 01 JAN
The remote signalling device fitted to your
alarm system is reporting a fault on the
telephone line. You may not be able to set
your system until you clear the fault. If it
persists, contact your alarm company.
AC Mains Fault
There is no mains power to the control unit
and the alarm system is running on its
standby battery. You may not be able to
set your system until the power is restored. If
the fault persists, the standby battery will
eventually run flat. Contact your alarm
company.
Battery Fault
The standby battery has developed a fault
or is disconnected. You may not be able to
set your system until the fault is cleared.
Contact your alarm company.
PANEL LID TAMPER
08:13:45 01/01
The lid of the control unit has been
removed. You may not be able to set your
system until the fault is cleared. Contact
your alarm company.