Operator`s manual

Specifications & Notes
Reference = -8 PPM, 0VU
Mic in (transformer balanced):
Min. input level -83 dBu (Z in = 1.4 k!)
Max. input, line position (no pad) +28 dBu
Mic/Line pad -40 dB Z
in "
10k!
PAD -15 dB Z
in "
600!
Combined -55 dB Z
in "
10k!
High Pass Filters:
HP1 100 Hz at 6 dB / oct
HP2 70 Hz at 12 dB / oct
O/L indicator 3 dB below M. O. L. (max output level)
Response 20 - 20 kHz +/- 0.5 dB
EIN (20 - 20 kHz, 150!) - 129.5 dBu
THD + N (20 - 20 kHz) .003%
Notes:
This module can be installed in any slot.
Channel 1 & 2 are drilled for an extra XLR.
(or a 5 pin XLR can be installed for the other slots).
Multiple modules can also be installed.
48 PH power can be changed to 12v PH (requires soldering).
(2) 1/4” jacks on the rear panel are provided for direct outs, pre- or post-fader.*
The pre-fader position can be before or after* the balance pot.
* Standard configuration.
M/S Decode:
Left channel = mid, Right channel = side.
With equal gain & the balance pot centered, the M/S mic configuration is decoded to 50%.
The stereo image width can be changed by altering the gain of one channel (either by the gain trims or the balance pot).
CSST-STERE0 MODULE
MODEL CS 208
8
Right Page
Right Page