Operator`s manual

Recorder Connections:

There are 2 types of outputs provided - balanced & unbalanced.

In general, the unbalanced outs are used to connect to unbalanced inputs.

eg: Nagra 4.2, IVS, wireless transmitters, semi Pro DATS.

The balanced outs are used for balanced inputs, long cable runs, & feeds to unfamiliar equipment.

eg: Video Assist, guest crews, etc.

(The transformer balanced outputs will provide greater isolation & protection from these devices.)

Nagra Connections:

IVS (unbalanced inputs).

The line input of the IVS is a current type & series resistors must be installed in the cable.

Nominal value of 47k! to 56k! in series with signal conductors.

(Use 1% metal film for interchannel matching & low noise - wattage is not important.)

4.2 (unbalanced input) no resistors required.

IVS Line ‘Input’ IVS ‘Output’ 4.2 ‘Mixer’

1. Ch. 2 1. Ch. 2 Out 1. Input

2. N/C 2. -10v 2. -10v

3. Ch. 1 3. Ch. 1 Out 3. N/C

4. N/C 4. N/C 4. N/C

5. N/C 5. N/C 5. Output

6. N/C 6. Stop 6. Stop

7. Ground 7. Ground 7. Ground

BASIC SET-UP

MODEL CS 208

Right Page