Operator`s manual

AN 2A - INPUT CHANNEL OPTIONS
MODEL CS 208
27
Direct Outs & Inserts
Standard configuration is Insert point (send/return) & Direct out post-fader.
For flexibility in the field, J5 is normally set at the B2 position, so the Insert jack can be either Insert or Direct out
pre-fader, depending on how the connecting cable is wired.
ie: For Direct out, pre-fader - jumper tip & ring of a 1/4” stereo jack plug.
To change Insert to Direct out, pre-fader only, move shunt to position A2 (J5 board A).
Insert jack becomes: Tip = Direct out, pre-fader. (nominal level -5 dBu.)
Ring = N/C.
A mono or stereo 1/4” jack plug can be used.
J5
J5 shunts only affect the Insert jack. • • • 1 (see AN 2B)
• • • 2 Insert
A B
• • • 1 Direct out,
• • • 2 Pre-fader
A B
Left Page
Left Page