Operator`s manual

MODEL CS 208

AFL, PFL (J6) Normally set for PFL (pre-fader listen) (position B).

PFL level to the phones is approximately equal to the level through the mix busses with the input fader at 0, & the pan

pots panned either left or right.

If changed to AFL (after fade listen), the level will be approximately 3 dB higher with the fader at ‘0’.

LED = O/L or Limiter

J7 A = limiter.

B = O/L only (standard configuration).

Position A - The LED indicates O/L if limiter is off, & limiter action, if limiter is on.

RP2 on board A may need to be adjusted. (see addendum 6.5.)

Mic Power

See layout A, J8.

Normally set for 48v phantom.

Move

both shunts to the left for 12v phantom power.

The 12T power is not affected.

AN 2C - INPUT CHANNEL OPTIONS

Left Page