Operator`s manual

MODEL CS 208
30
AN 2D - INPUT CHANNEL OPTIONS
Limiter Threshold
Threshold - normally set at +4 PPM, with the input fader a ‘0’.
Attack & release times are normally both set for ‘fast’. J3(A).
Should the attack and/or release times settings be changed, the threshold may need to be readjusted.
Limiter Threshold Adjustment (no external test equipment required.)
* Assign oscillator to C,D only (or Aux only).
* Switch input channel to
Line in.
* Switch out C,D from the mix bus on input channel & turn off Aux sends.
* Connect C,D or Aux outs to the input channel (short mic cable).
* Pan L or R for A,B busses & switch off Limiter.
* Set input fader at ‘0’.
* Adjust gain trim for full scale on A/B meters. (A/B masters at max.)
* Turn on Limiter, adjust threshold for +4 PPM (or desired level).
Right Page
Right Page