Operator`s manual

GENERAL NOTES
MODEL CS 208
33
Standard Configuration
All audio connectors are pin #2 hot. Mic ‘T’ powering is: Pin #2 + 12vDc.
Alternate phase to be specified at time of purchase.
Levels are set as specifications.
Meter types should be specified at time of purchase.
Access to Output Trimmers
All trimmers on the output module are accessible by removing the right side panel only (no need to remove the module).
Tools: 1/16” & 5/64” Allen wrenches.
Warning
The monitor outputs of this mixer are capable of driving low-impedance headphones at a very high level. Before head-
phones are in use, set all monitor levels at ‘0’ (eg: ‘off’). Prolonged listening at high volumes might affect your hearing.
Left Page
Left Page