User`s manual

Backup.

If you choose “OFF”, this function is disabled.

 SETUP-REC-EVENT: Setup of the event record (Fig3.2.16 Setup event record)

 MOTION DETECTION (Fig3.2.17 Setup motion detection):

 AREA: This is the detection area setup

There are three options to choose: ALL, PART, OFF

 ALL: All area will be detected.

 PART: The part selected will be detected. Use the “Up” “Down” “Left” and “Right” to choose the part

needed to be detected and use enter key to select/cancel the part. The part selected will be in blue and gray

part will not be detected.

 OFF: This function will be disabled.

 SEN: This is the sensitivity of the motion detection. You can use remote controller or the number button

on front panel to set any value of sensitivity from 0 to 9. The value is bigger, the sensitivity is higher.