User`s manual

41
5-2 PTZ
To make the PTZ camera function correctly, please follow the instructions below:
1. Connect the PTZ to RS232 port (via RS485-RS232 converter).
2. Refer to Chapter 5-7-2 to assign “PTZ” to the RS232 port you connected.
3. Refer to the user manual of PTZ to setup the protocol, baud rate and ID.
4. Select Camera: please select the correct camera number which has PTZ function.
5. Status: set to ”Enable”
6. Model, ID, and Baud Rate: set the ID the same as the PTZ camera.
You can control the PTZ camera using the control panel in this page.
: Focus near
: Focus far
: auto focus
Preset function:
1. Select p1reset point 1.
2. Move the PTZ camera to the position 1 using the panel.
3. Click “save”.