Speed Dome Camera Controller Operation Manual Please read this operation manual before using this device and use the device properly. Also, please keep this manual with care to ensure easy access at any time.
SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN! CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO DOT OPEN COVERS. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL The lighting flash with a arrowhead symbol, in an equilateral triangle, is intended to alert the user. There is uninsulated “dangerous voltage” presence near by the product's enclosure which may be risk of to persons .
INDEX I. Summary……………………………………………………………………………3 II. Introduction of Function…………………………………………………………...3 III. Introduction of the Keyboard’s Panel……………………………………………..3 IV. Setting of the Keyboard…………………………………………………………….4 V. Operation of the Keyboard…………………………………………………………5 VI. Installation and Connection…………………………………………………………7 VII. Technical Specifications……………………………………………………………..8 VIII. Points for Attention…………………………………………………………...…...
I. Summary The keyboard controller is used for terminal receivers such as the intelligent Speed Dome and the decoder etc. Taking the EIA/RS-485 electrical interface between the keyboard and the receiver, one keyboard can control as much as 32 speed dome and decoders without driving the bus and the maximum communication distance between the keyboard and the receiver is up to 1.2 km. It’s very easy for operating and setting the Speed Dome Camera.
MENU Figure 1 CAM：Select address of the intelligent Speed Dome . MENU：Auxiliary control buttons. AUTO：To control auto-horizontal rotation for pan/tilt. CLEAR： To clear inputted data 0-9： Number key WIDE：To a wide angle. TELE：To turn to a telescopic range. FAR：To make focus far manually. NEAR：To make focus near manually. OPEN：To open iris. CLOSE：To close iris. ON：Switch on the setting of function. OFF：Switch off the setting of function.
ID-Code in Figure 2.
V. Operation of the Keyboard 1. Select Address of Speed Dome Camera/Decoder：[N]+[ CAM] Description：N –– No. of camera from 0 to 64 Function：Select the address of the camera to be controlled. When the value N is in conformity with the address of the speed dome, it will be under control. 2. To set preset position：[N]+[ PRESET] Description：N –– No. of preset position from 1 to 64. Function：Store current position and refer it as No. N position. 3. Call the Preset position：[N]+[ CALL] Description:：N –– No.
11. Control the Iris of the Camera：[OPEN]/[CLOSE] 12. Auxiliary Control of the Camera：By combination of [MENU] and [ON], [OFF] buttons, you can set some data of the camera, and functions are listed as follows (operations of B01 Protocol): No.
power failure occurred; Operations under special case can be referred on the description of the menu of the ball machine. 13. Use the Joystick to Control the Speed Dome Camera： You can use the speed joystick to control the Pan/Tilt direction and speed of the dome of the camera randomly. The speed of pan/tilt is decided by the angle of the joystick you operated (Figure 3).
Communication connector: RS-485. Baud Rate of Communication：Four baud rates i.e. 2400Bps, 4800Bps, 9600Bps and 19200Bps. Distance of Communication：1200 M in maximum Power Supply：500 mA（the input voltage of power supply is variable for power supply’s specification） Size： 188 × 97 × 70（mm） Weight：0.5 Kg Number of Controlled Speed Dome Camera up to 32. VIII. Points for Attention： Please read the operation manual of the keyboard carefully before using it.
